Effect of fabrication parameters on coating properties of tubular solid oxide fuel cell electrolyte prepared by vacuum slurry coating
- Authors
- Son, Hui-Jeong; Song, Rak-Hyun; Lim, Tak-Hyoung; Lee, Seung-Bok; Kim, Sung-Hyun; Shin, Dong-Ryul
- Issue Date
- 2-4월-2010
- Publisher
- ELSEVIER SCIENCE BV
- Keywords
- Solid oxide fuel cell; Vacuum slurry coating; Thin electrolyte; Coating parameters; Polarization resistance
- Citation
- JOURNAL OF POWER SOURCES, v.195, no.7, pp.1779 - 1785
- Indexed
- SCIE
SCOPUS
- Journal Title
- JOURNAL OF POWER SOURCES
- Volume
- 195
- Number
- 7
- Start Page
- 1779
- End Page
- 1785
- URI
- https://scholar.korea.ac.kr/handle/2021.sw.korea/116646
- DOI
- 10.1016/j.jpowsour.2009.10.054
- ISSN
- 0378-7753
- Abstract
- The process of vacuum slurry coating for the fabrication of a dense and thin electrolyte film on a porous anode tube is investigated for application in solid oxide fuel cells. 8 mol% yttria stabilized zirconia is coated on an anode tube by Vacuum slurry-coating process as a function of pre-sintering temperature of the anode tube, vacuum pressure, slurry concentration, number of coats, and immersion time. A dense electrolyte layer is formed on the anode tube after final sintering at 1400 degrees C. With decrease in the pre-sintering temperature of the anode tube, the grain size of the coated electrolyte layer increases and the number of surface pores in the coating layer decreases. This is attributed to a reduced difference in the respective shrinkage of the anode tube and the electrolyte layer. The thickness of the coated electrolyte layer increases with the content of solid powder in the slurry, the number of dip-coats, and the immersion time. Although vacuum pressure has no great influence on the electrolyte thickness, higher vacuum produces a denser coating layer, as confirmed by low gas permeability and a reduced number of defects in the coating layer. A single cell with the vacuum slurry coated electrolyte shows a good performance of 620mWcm(-2) (0.7V) at 750 degrees C. These experimental results indicate that the vacuum slurry-coating process is an effective method to fabricate a dense thin film on a porous anode support. (C) 2009 Elsevier B.V. All rights reserved.
- Files in This Item
- There are no files associated with this item.
- Appears in
Collections - College of Engineering > Department of Chemical and Biological Engineering > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.