Valorization of Ferronickel Slag into Refractory Materials: Effect of Sintering Temperature

초록

Preparation of refractory materials from ferronickel slag by sintering over a broad temperature range (1200 degrees C to 1500 degrees C) with addition of sintered magnesia was explored. The thermodynamic calculations indicated that the amounts of newly generated high-melting-point forsterite and spinel phases increase with increasing temperature. The experimental analysis demonstrated that elevating the sintering temperature promoted conversion and crystallization of forsterite and spinel phases from the original phase of the slag, with simultaneous reduction of low-melting-point enstatite. There was also rapid growth of spinel grains from about 0.5m to 5m, which should be controlled by selecting an appropriate temperature. The results showed that, by sintering the slag at 1400 degrees C for 3h with addition of 20wt.% sintered magnesia, a high-quality refractory material with refractoriness of 1680 degrees C, bulk density of 2.93g/cm(3), apparent porosity of 1.81%, and compressive strength of 166.62MPa was obtained.

키워드