Detailed Information
Cited 0 time in 
Cited 0 time in 
Cited 0 time in
Metadata Downloads
Asymmetric rolling of strip-cast Al-5.5Mg-0.3Cu alloy sheet: Effects on the formability and mechanical properties
- Issue Date
- 15-6월-2011
- Publisher
- ELSEVIER SCIENCE SA
- Keywords
- Al alloy; Shear deformation; Mechanical properties; Formability; Textures
- Citation
- MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, v.528, no.15, pp.5223 - 5227
- Indexed
- SCIE
SCOPUS
- Journal Title
- MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
- Volume
- 528
- Number
- 15
- Start Page
- 5223
- End Page
- 5227
- ISSN
- 0921-5093
- Abstract
- Al alloy sheet with a composition of Al-5.5Mg-0.3Cu was successfully fabricated using a combined technique of twin-roll strip casting and asymmetric rolling. The Al sheet produced in this study exhibited an excellent formability ((r) over bar = 1.0, Delta r = 0.16) and mechanical properties (sigma(Ts) similar to 305 MPa, epsilon similar to 33%), far exceeding those shown by the commercially available Al sheets. The structural origin of these properties. especially the improved formability, was elucidated by analyzing the evolution of textures associated with strip casting and subsequent thermo-mechanical treatment. (C) 2011 Elsevier B.V. All rights reserved.
- Files in This Item
- There are no files associated with this item.
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.