Carbon dioxide capture in biochar produced from pine sawdust and paper mill sludge: Effect of porous structure and surface chemistry
- Authors
- Igalavithana, Avanthi Deshani; Choi, Seung Wan; Shang, Jin; Hanif, Aamir; Dissanayake, Pavani Dulanja; Tsang, Daniel C. W.; Kwon, Jung-Hwan; Lee, Ki Bong; Ok, Yong Sik
- Issue Date
- 15-10월-2020
- Publisher
- ELSEVIER
- Keywords
- CO2 sequestration; Charcoal; Engineered biochar; Greenhouse gas; Sustainable waste management
- Citation
- SCIENCE OF THE TOTAL ENVIRONMENT, v.739
- Indexed
- SCIE
SCOPUS
- Journal Title
- SCIENCE OF THE TOTAL ENVIRONMENT
- Volume
- 739
- URI
- https://scholar.korea.ac.kr/handle/2021.sw.korea/52447
- DOI
- 10.1016/j.scitotenv.2020.139845
- ISSN
- 0048-9697
- Abstract
- The CO2 concentration in the atmosphere is increasing and threatening the earth's climate. Selective CO2 capture at large point sources will help to reduce the CO2 emissions to the atmosphere. Biochar with microporous structure could be a potential material to capture CO2. The impact of feedstock type, pyrolysis temperature and steam activation of biochars were evaluated for CO2 adsorption capacity. Pine sawdust biochars were produced at 550 degrees C, and steam activated for 45 min at the same temperature alter completing the pyrolysis (PS550 and PSS550). Paper mill sludge biochars were produced at 300 and 600 degrees C (PMS300 and PMS600). The CO2 adsorption capacity of biochars was tested at 25 degrees C using a volumetric sorption analyzer. Pine sawdust biochars showed significantly higher CO(2 )adsorption capacity than paper mill sludge biochars due to high surface area and microporosity. Pine sawdust biochars were then evaluated for dynamic adsorption under representative post-combustion flue gas concentration conditions (15% CO2, 85% N-2) using a breakthrough rig. Both materials showed selective CO2 uptake over N-2 which is the major component along with CO2 in flue gas. PS5550 had slightly higher CO2 adsorption capacity (0.73 mmol g boolean AND(-1) vs 0.67 mmol g boolean AND(-1)) and CO2 over N-2 selectivity (26 vs 18) than PS550 possibly due to increase of microporosity, surface area, and oxygen containing basic functional groups through steam activation. Pine sawdust biochar is an environmentally friendly and low-cost material to capture CO2. (C) 2020 Published by Elsevier B.V.
- Files in This Item
- There are no files associated with this item.
- Appears in
Collections - College of Engineering > Department of Chemical and Biological Engineering > 1. Journal Articles
- College of Life Sciences and Biotechnology > Division of Environmental Science and Ecological Engineering > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.