BCl3-Based Dry Etching of Exfoliated (100) beta-Ga2O3 Flakes
- Authors
- Kim, Man-Kyung; Kim, Yukyung; Kim, Jihyun; Baik, Kwang Hyeon; Jang, Soohwan
- Issue Date
- 9-1월-2020
- Publisher
- ELECTROCHEMICAL SOC INC
- Keywords
- gallium oxide; dry etching; Etch rate; Inductively coupled plasma
- Citation
- ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY, v.9, no.7
- Indexed
- SCIE
SCOPUS
- Journal Title
- ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY
- Volume
- 9
- Number
- 7
- URI
- https://scholar.korea.ac.kr/handle/2021.sw.korea/58325
- DOI
- 10.1149/2162-8777/abae14
- ISSN
- 2162-8769
- Abstract
- We report on BCl3-based dry etching characteristics of (100)beta-Ga2O3 flakes using inductively coupled plasma etching technique, which were prepared by mechanical exfoliation from(2 over bar 01)<iGa(2)O(3) single crystal. The etch rate of (100) Ga2O3 flake increased with increasing bias rf powers up to 52 nm min(-1) using 25 sccm BCl3/15 sccm N-2 gas chemistry. We also examined the etch rate dependence of Ga(2)O(3)on crystal orientation. The (100) Ga2O3 flake has the lowest etch rate when compared with (010) and(2 over bar 01)<iGa(2)O(3) surfaces. The lowest etch rate of (100) Ga2O3 surface results from less Ga-O bond breaking efficiency and low dangling bond density on the surface. It is notable that (2 over bar 01)<iGa(2)O(3) surface is etched at higher rate than (010) and (100) Ga2O3 surfaces. The surface morphologies of etched (100) Ga2O3 surface exhibited little change, and rms roughness values remained less than 1.5 nm over a broad range of etch conditions.
- Files in This Item
- There are no files associated with this item.
- Appears in
Collections - College of Engineering > Department of Chemical and Biological Engineering > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.