Detailed Information

Cited 0 time in webofscience Cited 0 time in scopus
Metadata Downloads

Performance Characterization of a Silicon Drift Detector for Gamma Ray Imaging

Authors
Joung, JinhunLee, KisungAhn, Young BokLee, Jong HeeKang, JihoonMoon, Jae KukHenseler, DeboraMetzger, WilhelmSchmand, Matthias
Issue Date
Jun-2010
Publisher
IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC
Keywords
Gamma camera; high resolution; positioning scheme; silicon drift detector; solid-state detector
Citation
IEEE TRANSACTIONS ON NUCLEAR SCIENCE, v.57, no.3, pp.931 - 937
Indexed
SCIE
SCOPUS
Journal Title
IEEE TRANSACTIONS ON NUCLEAR SCIENCE
Volume
57
Number
3
Start Page
931
End Page
937
URI
https://scholar.korea.ac.kr/handle/2021.sw.korea/116295
DOI
10.1109/TNS.2009.2038696
ISSN
0018-9499
Abstract
This study examined the intrinsic performance of silicon drift detector (SDD)-based gamma detectors under a variety of conditions. The prototype detector consisted of an array of seven hexagon-shaped SDDs optically coupled to a single slab of a scintillator. The active area of the SDD sensor was 15.2 mm in diameter, as measured from one vertex to another. The detector unit (SDD array, scintillator and preamplifier circuits) was operated in a cooling chamber with a typical operating temperature of -20 degrees C. Nitrogen gas was supplied to the detector unit to prevent condensation. The drift time was measured using a LED pulse generation device and the longest drift time was measured to be 4.6 mu sec from the edge of the sensor. The intrinsic energy resolution with a (55)Fc source for direct X-ray conversion was 3% at the 5.9 keV peak. For indirect conversion, i.e. photon detection, the energy resolution for CsI(Tl) and NaI(Tl) was 7.9% and 8.2% with a 13 mu sec and 2.71 mu sec shaping time, respectively. For this indirect conversion measurement, the temperature was set to -20 degrees C and a 1 x 1 x 1 cm(3) cube scintillator was coupled directly to the sensor. For the intrinsic spatial resolution measurement with a hole-phantom (3 x 2 mm diameter holes), the x and y directional profiles at a center hole were 2.2 and 2.1 mm in FWHM, respectively. Overall, the intrinsic performance of the SDD prototype is quite promising and advantages of this technology makes it highly feasible for use as a gamma ray detector.
Files in This Item
There are no files associated with this item.
Appears in
Collections
Graduate School > Department of Bioengineering > 1. Journal Articles

qrcode

Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.

Related Researcher

Researcher Lee, Ki sung photo

Lee, Ki sung
Department of Bioengineering
Read more

Altmetrics

Total Views & Downloads

BROWSE